Messages

1

DAQ Software/Firmware / Re: mscam frame retrieval error, three LEDs

« on: October 15, 2016, 05:28:37 PM »

Thanks! The problem seems to have been number 1. I was able to fix the issue by disconnecting the scope from the DAQ while the DAQ was powered on, then reconnecting the scope with the DAQ powered off. Now it transmits images at max framerate, without any errors.

2

DAQ Software/Firmware / mscam frame retrieval error, three LEDs

« on: October 14, 2016, 04:25:03 PM »

Hi,

so I see all three DAQ LEDs light up when I connect the scope to the DAQ, and I can adjust the excitation LED power. But I always get an mscam frame retrieval error and a red screen. My system is windows 7 SP1 64-bit. If anyone has any ideas on what might be causing this, that would be great, thanks!

3

DAQ Software/Firmware / Re: Issues Uploading Firmware

« on: September 22, 2016, 04:18:05 PM »

Thanks for the help! It seems that the firmware file I downloaded had somehow been corrupted (it wasn't even the right file size). I couldn't even program RAM with this file. Downloading it again seems to have fixed this issue, now the DAQ enumerates as 'MINISCOPE'.

4

DAQ Software/Firmware / Re: Issues Uploading Firmware

« on: September 21, 2016, 05:18:30 PM »

Hi,

I can't get the DAQ to enumerate as 'MINISCOPE' after firmware upload. I've followed the instructions under software and firmware setup, and although Cypress control displays a message that EEPROM programming was successful, the DAQ still enumerates as
"Cypress FX3 USB bootloader device". When I try to program flash, Cypress fails with the message "Programming invalid firmware signature". I've tried both windows 7 and windows 8.1 machines, and versions 1.3.3 and 1.3 of the Cypress SDK
(I think 1.3 was used during development, is this correct?). They all give the same result. Any help would be great, thanks!