1
DAQ Software/Firmware / Re: Inconsistent error
« on: November 04, 2016, 08:49:15 PM »
Re-soldering solved the problem! 
News:
The Miniscope Forum Board uses a separate account from your Miniscope.org
Our old Discussion Board can be found at http://miniscope.org/index.php?title=Special:WikiForum
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
DAQ Software/Firmware / Re: Inconsistent error
« on: November 01, 2016, 10:34:55 PM »
Sounds good! I'll post an update once I try new cable/re-soldering. See you at SfN.
3
DAQ Software/Firmware / Re: Inconsistent error
« on: November 01, 2016, 09:17:17 PM »
Hi Daniel,
Please see below for answers.
1. Yes I see a live video stream show up. On some trials I even adjusted the gain/frame rates but then it'd crash. The longest time I kept it on (without manipulating any parameters) was for 7 minutes.
2. I had a webcam plugged in. It only works when I connect the Miniscope before the webcam. When I have only the webcam connected, it only connects by the scope connect button.
3. Yes all 3 LEDs are on.
Hope my answers are clear.
Please see below for answers.
1. Yes I see a live video stream show up. On some trials I even adjusted the gain/frame rates but then it'd crash. The longest time I kept it on (without manipulating any parameters) was for 7 minutes.
2. I had a webcam plugged in. It only works when I connect the Miniscope before the webcam. When I have only the webcam connected, it only connects by the scope connect button.
3. Yes all 3 LEDs are on.
Hope my answers are clear.
4
DAQ Software/Firmware / Inconsistent error
« on: November 01, 2016, 06:17:19 PM »
Hi,
I am experiencing inconsistency in the Miniscope Controller operation. I've tried connecting the scope to three different Windows 10 computers but the software crashes after varying delays (see attached for a sample screenshot). I've never seen a "red screen" though. Has any one encountered the same problem?
I am experiencing inconsistency in the Miniscope Controller operation. I've tried connecting the scope to three different Windows 10 computers but the software crashes after varying delays (see attached for a sample screenshot). I've never seen a "red screen" though. Has any one encountered the same problem?
Pages: [1]