Difference between revisions of "Software and Firmware Setup"
From UCLA Miniscope
(→Installing DAQ Software) |
(→Installing DAQ Software) |
||
| Line 4: | Line 4: | ||
== Installing DAQ Software == | == Installing DAQ Software == | ||
| − | Current and past DAQ software packages can be found [[DAQ Software|here]]. To run the software, extract all files into the same folder and run MiniScopeControl.exe. | + | Current and past DAQ software packages can be found [[DAQ Software Downloads|here]]. To run the software, extract all files into the same folder and run MiniScopeControl.exe. |
Revision as of 15:15, 7 January 2016
This guide will show you how to upload the miniscope firmware to the DAQ system and install the DAQ software on a PC.
Uploading Firmware
The USB Host Control on the DAQ PCB requires firmware to run. The firmware is written and compiled using the Cypress EZ-USB FX3 SDK. This SDK also comes with Cypress Control Center which can be used to upload the firmware image to the RAM of the USB Host Controller or, more likely, to the EEPROM on the DAQ PCB.
Installing DAQ Software
Current and past DAQ software packages can be found here. To run the software, extract all files into the same folder and run MiniScopeControl.exe.
