Difference between revisions of "Software and Firmware Setup"
From UCLA Miniscope
(Created page with "This guide will show you how to upload the miniscope firmware to the DAQ system and install the DAQ software on a PC. == Uploading Firmware == == Installing DAQ Software ==") |
(→Uploading Firmware) |
||
| Line 1: | Line 1: | ||
This guide will show you how to upload the miniscope firmware to the DAQ system and install the DAQ software on a PC. | This guide will show you how to upload the miniscope firmware to the DAQ system and install the DAQ software on a PC. | ||
== Uploading Firmware == | == Uploading Firmware == | ||
| + | The USB Host Control on the DAQ PCB requires firmware to run. The firmware is written and compiled using the Cypress EZ-USB FX3 SDK. This SDK also comes with Cypress Control Center which can be used to upload the firmware image to the RAM of the USB Host Controller or, more likely, to the EEPROM on the DAQ PCB. | ||
| + | |||
== Installing DAQ Software == | == Installing DAQ Software == | ||
Revision as of 22:05, 5 January 2016
This guide will show you how to upload the miniscope firmware to the DAQ system and install the DAQ software on a PC.
Uploading Firmware
The USB Host Control on the DAQ PCB requires firmware to run. The firmware is written and compiled using the Cypress EZ-USB FX3 SDK. This SDK also comes with Cypress Control Center which can be used to upload the firmware image to the RAM of the USB Host Controller or, more likely, to the EEPROM on the DAQ PCB.
