Author Topic: DAQ PCB - SMA connector for trigger  (Read 3192 times)

eliott335

  • Newbie
  • *
  • Karma: +0/-0
    • View Profile
DAQ PCB - SMA connector for trigger
« on: June 30, 2017, 10:25:17 PM »
Hi,

I am trying to use a signal to trigger the miniscope as described in the wiki (http://miniscope.org/index.php?title=Data_Acquisition_Box) but I have the newer version of the DAQ PCB board and I am not sure which SMA is programmed to receive the input. (and I am scared to burn the PCB by plugging an input in an output SMA). You specified on the forum that the left 2 SMA connectors handle optional triggering and sync signals (http://miniscope.org/board/index.php?topic=352.0) but could you specify what are each of them (J3 and J5) are programmed to do?

Thanks a lot and happy 7/4 weekend !

Eliott

Daniel Aharoni

  • Administrator
  • Full Member
  • *****
  • Karma: +15/-0
    • View Profile
Re: DAQ PCB - SMA connector for trigger
« Reply #1 on: June 30, 2017, 11:45:14 PM »
Hi Elliot,
This is a great question and is information that needs to be added to the wiki. In the meantime take a look at this thread, http://miniscope.org/board/index.php?topic=377.0 . It should address your question.