Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - syhuang

Pages: [1]
1
Hi Daniel,

Thank you so much. I will do the same way.

2
It seems that the screws listed in the part list do not fit. Thanks!

Shiyong

3
System Assembly Troubleshooting / Re: Soldering SMA cable to DAQ PCB v2.3
« on: October 11, 2016, 07:00:35 PM »
Hi Daniel,

It is very clear now. Thank you so much!

Shiyong

4
System Assembly Troubleshooting / Soldering SMA cable to DAQ PCB v2.3
« on: October 11, 2016, 05:07:22 PM »
The layout in v2.3 is different to that in v2.01. I am confused about how to solder the SMA cable to the DAQ PCB while watching the video in the guide.

BTW, just would like to confirm that the SW4 (Reset button) also need to be soldered since Daniel mentioned that the new design requires no soldering.

Thanks.

Pages: [1]