1
Electronics / Re: led of different color
« on: July 24, 2017, 03:25:41 PM »
Thanks.
News:
The Miniscope Forum Board uses a separate account from your Miniscope.org
Our old Discussion Board can be found at http://miniscope.org/index.php?title=Special:WikiForum
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Electronics / led of different color
« on: July 21, 2017, 09:56:33 PM »
Hi, Daniel,
I am thinking about buying LED and filters for red color. I found that LUXEON has 2 square mm LED of lime color which fits spectra of the filter set I want to have. But its forward voltage is slightly different from the blue one (2.75 V vs 2.95 V). Do you think this lime LED will work with the camera PCB? Thanks a lot.
Baohua
I am thinking about buying LED and filters for red color. I found that LUXEON has 2 square mm LED of lime color which fits spectra of the filter set I want to have. But its forward voltage is slightly different from the blue one (2.75 V vs 2.95 V). Do you think this lime LED will work with the camera PCB? Thanks a lot.
Baohua
3
DAQ Software/Firmware / Re: External Triggering
« on: June 30, 2017, 03:38:06 AM »
Thanks a lot, Daniel. It is easier to solder an coax cable than changing codes.
4
DAQ Software/Firmware / Re: External Triggering
« on: June 14, 2017, 10:51:52 PM »
Hello Daniel,
I was trying to externally trigger the miniscope, but could not make it work. I have the version 3.2 daq and assume the digital port 1 is the "trigger in" since the digital port 2 sends out TTL pulses corresponding to individual frames. I first connected the scope with the miniscope controller by pressing the "connect" button. The weird thing was that when I selected "trigger ext", the "Record" button became grey and inactive. Then if I pressed the "connect" again, "record" button came back. But pressing the "record" button did not make the camera run even when digital port 1 was high. Do you have any idea of what could be wrong? Thanks.
Baohua
I was trying to externally trigger the miniscope, but could not make it work. I have the version 3.2 daq and assume the digital port 1 is the "trigger in" since the digital port 2 sends out TTL pulses corresponding to individual frames. I first connected the scope with the miniscope controller by pressing the "connect" button. The weird thing was that when I selected "trigger ext", the "Record" button became grey and inactive. Then if I pressed the "connect" again, "record" button came back. But pressing the "record" button did not make the camera run even when digital port 1 was high. Do you have any idea of what could be wrong? Thanks.
Baohua
Pages: [1]