Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - ryancameron

Pages: [1]
Optics / Calibration
« on: July 02, 2018, 04:20:20 PM »
Hello all, I have been trying to calibrate two of our miniscope systems for a month now and have not had any success. I have used 1.0mm diameter by 9 mm long GRIN lenses as well as .6mm x 7.5mm GRIN lens. I have tried imaging with the calibration slide at all of the focal heights the Miniscope will allow, and still can't get a clear picture of the lines on the slide.

I was wondering if I could get in direct contact with someone who has successfully calibrated the system, so I could take a look at the procedures to try and find where I went wrong.

Ryan Cameron

Pages: [1]