1
DAQ Software/Firmware / Issues Uploading Firmware
« on: August 08, 2016, 03:50:29 PM »
Hello,
I am trying to upload the firmware to my DAQ PCB right now. When I plug it in, I see the bottom two LEDs light up. I had to manually install the drivers, and I see "Cypress FX3 USB Bootloader Device" instead of just Cypress USB Bootloader."
When I do press Program, FX3, and then I2C EEPROM, it says "Waiting for Cypress Boot Programmer device to enumerate" and then "Cypress Boot Programmer Device not found" after a few seconds.
I am not sure how to troubleshoot this.
Thanks.
I am trying to upload the firmware to my DAQ PCB right now. When I plug it in, I see the bottom two LEDs light up. I had to manually install the drivers, and I see "Cypress FX3 USB Bootloader Device" instead of just Cypress USB Bootloader."
When I do press Program, FX3, and then I2C EEPROM, it says "Waiting for Cypress Boot Programmer device to enumerate" and then "Cypress Boot Programmer Device not found" after a few seconds.
I am not sure how to troubleshoot this.
Thanks.