Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - hahnj

Pages: [1]
1
Behavior / Re: Sync Behavior - More TTLs sent than frames recorded
« on: November 05, 2018, 02:24:17 PM »
Dear Daniel,

Thanks, I will have a look.

2
Behavior / Sync Behavior - More TTLs sent than frames recorded
« on: October 29, 2018, 02:33:30 PM »
I realized that when I record the TTLs that the miniscope sends for each recorded frame I always end up with more pulses/timestamps than frames recorded. The difference ranges from very few up to more than 100.

I couldn't find any correlation between the difference and recording length.
It is always more timestamps than frames.
The timestamp.dat file corresponds to the number of frames recorded.
The time difference between all TTL-timestamps recorded is the same (so I cannot exclude some timestamps just by looking at the difference).
=> It looks like the Miniscope sends the TTLs before starting the recording or is still sending TTLs after the Recording stopped (Or both).

Any ideas what could cause this or possible solutions?

 

Pages: [1]