Show Posts
1
DAQ Software/Firmware / problem changing excitation LED power
« on: November 28, 2016, 11:29:36 AM »
Dear all,
I am having an issue changing the intensity of the excitation LED using the GUI:
- All 3 LEDs on the DAQ board are on
- on the image sensor PCB there is a red LED on
- the blue excitation LED is illuminated when I plug in the USB cable
- I am able to connect to the scope and the sensor appears to be working, but when I change the excitation LED power nothing happens, although the message window in the GUI says: 'LED power updated: 0' up until 'LED power updated: 100'
I was wondering if anyone has encountered this issue before? Any suggestions what to check/try are greatly appreciated!
best, Jasper
I am having an issue changing the intensity of the excitation LED using the GUI:
- All 3 LEDs on the DAQ board are on
- on the image sensor PCB there is a red LED on
- the blue excitation LED is illuminated when I plug in the USB cable
- I am able to connect to the scope and the sensor appears to be working, but when I change the excitation LED power nothing happens, although the message window in the GUI says: 'LED power updated: 0' up until 'LED power updated: 100'
I was wondering if anyone has encountered this issue before? Any suggestions what to check/try are greatly appreciated!
best, Jasper