Miniscope Board

General Category => Electronics => Topic started by: eliott335 on June 30, 2017, 10:25:17 PM

Title: DAQ PCB - SMA connector for trigger
Post by: eliott335 on June 30, 2017, 10:25:17 PM
Hi,

I am trying to use a signal to trigger the miniscope as described in the wiki (http://miniscope.org/index.php?title=Data_Acquisition_Box) but I have the newer version of the DAQ PCB board and I am not sure which SMA is programmed to receive the input. (and I am scared to burn the PCB by plugging an input in an output SMA). You specified on the forum that the left 2 SMA connectors handle optional triggering and sync signals (http://miniscope.org/board/index.php?topic=352.0) but could you specify what are each of them (J3 and J5) are programmed to do?

Thanks a lot and happy 7/4 weekend !

Eliott
Title: Re: DAQ PCB - SMA connector for trigger
Post by: Daniel Aharoni on June 30, 2017, 11:45:14 PM
Hi Elliot,
This is a great question and is information that needs to be added to the wiki. In the meantime take a look at this thread, http://miniscope.org/board/index.php?topic=377.0 . It should address your question.